Installing The System Top Cover (Front); Removing The System Top Cover (Back) - Dell PowerEdge C4130 Owner's Manual

3. system top cover (front)

Installing the system top cover (front)

Prerequisites
1. Ensure that you read the
2. Ensure that all internal cables are connected and routed correctly.
NOTE: Closing the system cover with incorrect cable routing can damage the cables.
Steps
1. Align the slots of the system top cover with the tabs on the chassis.
2. Slide the cover toward the back of the chassis until it locks into place.
3. Turn the system cover lock to the locked position.
Next steps
CAUTION: Turn on the system only when both the system top covers are installed.
Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

Removing the system top cover (back)

Prerequisites
CAUTION: Do not operate the system without the system cover. This can result in overheating
and cause component damage.
1. Ensure that you read the
2. Turn off the system, including any attached peripherals.
3. Disconnect the system from the electrical outlet and disconnect the peripherals.
4. Remove the system from the rack.
5. Keep the Phillips #1 screwdriver ready.
Steps
1. Remove the screws securing the system top cover to the chassis.
2. Slide the system top cover toward the back of the system.
3. Hold the cover on both sides, and lift the cover away from the system.
Safety instructions.
Safety instructions.
39