System Battery; Replacing The System Battery - Dell PowerEdge C4130 Owner's Manual

System battery

Replacing the system battery

Prerequisites
NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should be
performed only by Dell certified service technicians.
WARNING: There is a danger of a new battery exploding if it is incorrectly installed. Replace the
battery only with the same or equivalent type recommended by the manufacturer. For more
information, see the safety information that shipped with your system.
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you read the
2. Follow the procedure listed in
3. Disconnect the GPU signal and power cables from the system board.
Steps
1. Locate the battery socket.
CAUTION: To avoid damage to the battery connector, you must firmly support the connector
while installing or removing a battery.
2. Place your finger between the securing tabs at the negative side of the battery connector, and lift the
battery out of the socket.
Figure 20. Removing the system battery
1. negative side of the battery connector
68
Safety instructions.
Before working inside your system.
2. system battery