Installing The Cable Routing Clip; System Board; Removing The System Board - Dell PowerEdge C4130 Owner's Manual

Installing the cable routing clip

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you read the
2. Follow the procedure listed in
Steps
1. Align the screw holes on the cable routing clip with the screw holes on the system board and lower
the clip on the system board.
2. Secure the cable routing clip to the system board by using the screws.
Next steps
1. Connect and route the cables through the cable routing clip.
2. Follow the procedure listed in

System board

Removing the system board

Prerequisites
NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should be
performed only by Dell certified service technicians.
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
CAUTION: If you are using the Trusted Platform Module (TPM) with an encryption key, you may
be prompted to create a recovery key during program or System Setup. Be sure to create and
safely store this recovery key. If you replace this system board, you must supply the recovery key
when you restart your system or program before you can access the encrypted data on your hard
drives.
CAUTION: Do not attempt to remove the Trusted Platform Module (TPM) from the system board.
Once the TPM is installed, it is cryptographically bound to that specific system board. Any
attempt to remove an installed TPM breaks the cryptographic binding, and it cannot be re-
installed or installed on another system board.
1. Ensure that you read the
2. Follow the procedure listed in
3. Keep the Philips #2 screwdriver ready.
4. Remove the following components:
a. PCIe shroud. See
102
Safety instructions.
Before working inside your
After working inside your
Safety instructions.
Before working inside your
Removing the PCIe shroud
system.
system.
system.