Brickcom CB-100A series User Manual page 42

video codec at MJPEG is selected. Set the bitrate higher for a better video quality.
However, high bitrate may cost high network bandwidth resources.
The video qualities are selectable at the following settings: Level 1 to Level 6, Level 6 gives
the best image quality.
HTTP Transport – Enable to use HTTP protocol for video/audio communication.
Click Apply or Reset to take effect.
NOTE - For best recording experience, configure your IP camera to one of the following
frame rates based on the Flicker-Free setting:
Flicker-Free
------------------------------------
Outdoor
Indoor (50/60 Hz )
Video Overlay
Check to enable the timestamp function and select display position from the drop-down menu if
user wants date and time to be shown on the screen of the live video. User may also enable and
enter the video description in text box; and select display position from the drop-down menu if
user wants to make a note about the network camera. Click Apply or Reset to take effect.
NOTE - The video overlay only takes effect in stream 1.
Frame Rate
----------------------------------
25, 10, 7, 5, 3, 2
25, 20, 10, 7, 5, 3, 2
- 33 -