Attaching A Viewfinder - Sony CA4000 Operation Manual

5
Lower the handle, and secure the unit to the video
camera using the camera mounting screws.
Note
Before lowering the handle, check that the catch lever is
fully pushed down. If the handle is lowered without
pushing down the catch lever, the unit may be damaged.
To remove from the video camera
Follow the attachment procedure in the reverse order.
Note
After removing the unit from a camera, check that the catch
lever is fully pushed down and then lower the handle. If the
handle is lowered without pushing down the catch lever, the
unit may be damaged.

Attaching a Viewfinder

Caution
When the viewfinder is attached, do not leave the camera with
the eyepiece facing the sun. Direct sunlight can enter through
the eyepiece, be focused in the viewfinder and cause a fire.
Notes
• Attach/remove the viewfinder while the power supply is
turned off.
• When attaching an DVF-L700, first turn on the POWER
SWITCH of the DVF-L700 before turning on the power
supply to the unit.
For details about attaching viewfinders, refer to the operating
instructions for the viewfinder.
1
Loosen the lock ring of the viewfinder shoe, align with
the slot of the viewfinder, then attach the viewfinder
by sliding it horizontally.
Viewfinder shoe
2
Tighten the lock ring after determining the left and
right position of the viewfinder, then connect the
viewfinder cable to the VF-A or VF-B connector of the
unit.
Note
Connect the viewfinder cable to the VF-A connector if
using an HDVF-series viewfinder or to the VF-B connector
if using a DVF-series viewfinder.
To remove the viewfinder
Loosen the lock ring for the viewfinder, raise the stopper, then
remove the viewfinder by sliding it in the reverse direction than
when attaching it.
Attaching the Cable Clamp Belt
(Supplied)
You can secure the optoelectrical cable connected to the BPU
connector to the side of the unit by attaching the supplied
cable clamp belt.
1
Pass the belt bracket through hole
clamp belt.
Belt bracket
of the cable
A
A
13
Connection and Setup