Table of Contents
Advertisement
MAINTENANCE
Page name
Item
Page No.
<PROMPTER2 OUT>
OUTPUT
M09 (U14)
VBS-OUT
DOWN CONVERTER
SYNC-OUT
<SDI OUT>
SDI-MONI OUT
M10 (U15)
EMB AUDIO
<TRUNK>
REMOTE SELECT
M11
<GENLOCK>
REFERENCE
M12
GENLOCK
PHASE
<AUDIO INPUT SEL>
AUDIO IN
M13
<F55 AUDIO SET1>
INPUT
M14
WIND FILTER
OUTPUT
40
Menu List
Settings
PROMPTER2, SD-SYNC,
HD-SYNC, VF, VBS
CHARACTER
ON, OFF
GAIN
–99 to +99, 0
CHROMA
–99 to +99, 0
SETUP
ON, OFF
SELECT
MAIN, RET, VF
ASPECT
SQ, EC
V-PHASE
–999 to +999, 0
H-PHASE
–999 to +999, 0
MAIN, VF, RET, HD-PROMPT,
OFF
CHARACTER
ON, OFF
OFF, F55 MIC, CA MIC, PGM
(1-MIC1 2- ---)
(3-AES1 4-AES2)
(1-PGM1 2-PGM2)
(3-ENG 4-PROD)
RM, TRUNK
CCU, INTERNAL, GENLOCK
ENABLE, DISABLE
STATUS
FORMAT
V
–1024 to +1023, 0
H
–1700 to +1700, 0
F55, CA, MIC-F55 AES-CA
MIC CH1 REF
–60dB, –50dB, –40dB
MIC CH2 REF
–60dB, –50dB, –40dB
LIMIT
OFF, –6dB, –9dB, –12dB, –15dB,
–17dB
CH1
OFF, ON
CH2
OFF, ON
CH
CH1/CH2
MONITOR
CH1/CH2, CH1, CH2
Description
Note
VBS output is not supported when the format is
23.98P or 24P.
Displayed when OUTPUT is VBS.
Displayed when format is NTSC (SY model).
Displayed when OUTPUT is VBS.
Displayed when OUTPUT is SD-SYNC or HD-SYNC.
Display only
Display only
Display only
Display only
Displays sync status
Not displayed when a CCU or BPU is connected.
Selects the audio signal input.
Only CA is enabled when CHU MODE is set to F65.
Enabled only when CHU MODE is set to F55.
Selects the reference input level when the AUDIO IN
CH1 switch is set to MIC.
Selects the reference input level when the AUDIO IN
CH2 switch is set to MIC.
Selects the limiter characteristic (saturation level) for
strong input signals when adjusting the audio input
level manually.
OFF: Do not use limiter.
Turns the Window Filter function on/off.
Selects the audio output.
Selects the monitor audio output.
Advertisement
Table of Contents
