Connection And Setup - Sony CA4000 Operation Manual

Connection and Setup

Attaching to a Video Camera
This section describes the attachment of a PMW-F55 as an
example.
For details about attaching an F65, refer to the SKC-4065
Operation Guide.
For details about the handling of video cameras, refer to the
operating instructions supplied with the video camera.
Notes
• Requires PMW-F55 software version 2.10 or later.
• Attach to or remove from the video camera while the power
supply is turned off.
• Attach the unit to or remove it from the video camera with the
viewfinder detached. If the unit is attached or removed while
the viewfinder is still attached, the viewfinder will interfere
with the handle, causing the handle to drop and potentially
pinching your fingers.
1
Remove the four screws from the top of the video
camera, and remove the handle from the video
camera body.
12
Connection and Setup
2
Press and hold the handle flip-up lock release button,
and raise the handle of the unit.
1
3
Press the release button (
lever, and lift the lever all the way up (
2
1
4
Insert the tabs on the unit into the grooves on the rear
panel of the video camera (
lever down ( ).
2
1
Notes
• Check that the catch lever is pulled up before attaching
to the camera.
• Check that all four tabs are inserted correctly before
pulling the lever down. Failure to do so will result in mis-
seating of the unit and possibly damage.
2
) to release the catch
1
).
2
), then push the catch
1
2