Assembly B: Footrest; Adjusting The Foot Rests/Tube Foot Rest/Foot Plates; Replacing The Footrest Adapter; Replacing The Footrest - Otto Bock Discovery tmax Service Manual

3.6 Assembly B: Footrest

3.6.1 Adjusting the Foot Rests/Tube Foot Rest/Foot Plates

All instructions concerning the adjustment of the foot rests are included in the Instructions for Use (qualified per­
sonnel) – order number 647G585.

3.6.2 Replacing the Footrest Adapter

1) Loosen the Allen head screws on the seat frame (see Fig. 13, item 1).
2) Remove the lashing point if applicable.
3) Remove and replace the footrest adapter.
4) Bring the footrest adapter to the desired position (see Fig. 13, item 2).
INFORMATION: Note the minimum insertion depth. The footrest adapter needs to be secured with 2
screws.
5) Tighten all Allen head screws to a torque of 10 Nm.

3.6.3 Replacing the Footrest

1) If necessary: open the calf band and disengage it from the holder. Flip the footplate up.
2) Release the footrest locking mechanism (see Fig. 14) and swing the foot rest 90° to the outside (see Fig. 15).
3) Pull the footrest up, remove and replace it.
4) Slide the footrest into the holder on the front frame tube from above (see Fig. 16). The footrest has to face out
by 90°.
5) Swing the footrest in until the locking mechanism engages.
6) Fold down the footplate. If necessary: engage the calf band on the holder (see Fig. 17, item 1) and adjust the
length of the calf band. In order to do so, open/adjust/close the hook-and-loop closure (see Fig. 17, item 2).
discovery tmax
11
13
Service Work
12
Ottobock | 13