Advertisement
12
3. Press the
On/
Off button. The dishwasher
must be in setting mode.
4. Press the programme
selection/
cancel
button until the light corresponding to the
requ ired washing programme comes on
(see "Washing programmes" chart).
Close the dishwasher
door,
the pro-
gramme starts
automatically.
Setting and starting the programme with
delay start
CIl
The start of the washing programme w
ill
be delayed
by
3
hours.
1. Select a washing programme.
2.
Press the
delay
start button. The corre-
sponding indicator light comes on.
3
.
Close the dishwasher door. The count-
down starts automatically.
CIl
Opening the door
will
interrupt the
countdown
.
Once the door is closed the
countdown
will
continue from the point
at which it was interrupted.
4
.
Once the countdown has elapsed the
washing programme
will
start
automatically.
Cancel
a delay start in progress
1.
Open the dishwasher door.
2. Press the
delay
start button. The corre-
sponding indicator light goes off.
3. Close the dishwasher
door.
The washing
programme
will
start automatically.
ill
Warning! Interrupt or cancel a
washing programme in progress
ONLY if it's absolutely necessary.
Attention! Hot steam may escape
when the door is opened. Open the
door carefully.
Unloading the
dishwasher
•
Hot dishes are sensitive to knocks. The
dishes should therefore be allowed to cool
down before removing from the appliance.
•
Empty the lower basket first and then the
upper one; this
will
avoid water dripping
from the upper basket onto the dishes in
the
low
er one.
•
Water may appear on the sides and the
door of the dishwasher as the stainless
Interrupt a washing programme
in
progress
Open the dishwasher door; the programme
will
stop.
Close the door; the programme will
start from the point at which it was interrup-
ted.
Cancel a washing programme in
progress
•
Open the dishwasher door; press the pro-
gramme
selection/
cancel button for about
3
seconds, until
the light of the runn ing
programme goes off and the
End
indicator
light flashes. The washing programme has
been cancelled and the appliance is now
in setting mode ..
• If a new washing programme is to be se-
lected
,
check that there is detergent in the
detergent dispenser.
End of the washing programme
• The dishwasher will automatically stop and
an audible signal informs you of the end of
the washing
programme.
•
Open the dishwasher
door.
•
The
End
of programme indicator light is
on.
•
The indicator light of the programme just
ended remains on.
1. Switch off the dishwasher
by
pressing the
On/
Off button
.
2.
Leave the
dishw
asher door ajar and wait
a few minutes before removing the
dishes; in this way
they will
be cooler and
the drying will be improved.
steel w
ill eventually
become cooler than
the dishes.
CIl
When the washing programme has
finished,
it is recommended that the
dishwasher is unplugged and the
water tap turned off.
Advertisement
