Advertisement
2. Fill the
detergent dispenser
(1)
with
de-
tergent.
The marking indicates the dosing
levels:
20
=
approximately 20 g of detergent
30
=
approximately 30 g of detergent.
3.
All
programmes with
prewash
need an
additional
detergent
dose (5/10 g) that
must be placed in the prewash detergent
chamber (2).
This detergent will be used during the
prewash phase.
When
using
detergent
tablets; place the
tablet in com
artm ent
(1)
4.
Close the lid and press until it
locks in
place
.
rn
Select the washing programme with
the door slightly opened. The start of
the programme will occur only after
the closure of the door. Until then it
is possible to modify the settings.
11
rn
Detergent tablets from different manu-
facturers dissolve at different rates. For
this reason, some detergent tablets do
not attain their full cleaning power during
short washing programmes. Therefore,
please use
long
washing programmes
when
using detergent tablets, to ensure
the complete removal of detergent
residuals.
Use of combi detergent tablets
These products are detergents with a com
-
bined cleaning, rinsing and salt
functions.
They can also contain other different agents
depending on which kind of tablets
you
choose
("3 in
1
",
"4 in
1
",
"5
in 1"
etc ...
).
1. Check
whether
these detergents are
suitable for
your water
hardness. See the
manufacturers
instructions.
The refilling of the salt container and the
rinse
aid dispenser are no
longer
necessary. In this case the rinse aid
indi-
cator
light
will always remain illuminated
when the machine
is
switched on.
2. Select the
lowest
setting for
water
hard-
ness and rinse aid dosage.
If the drying results are not satisfactory
we recommend that you:
1. Fill up the rinse aid dispenser
with
rinse
aid.
2. Set the rinse aid dosage to position
2.
If you decide to turn back to the use of
standard detergent system we advise
that you:
1. Fill up the dispensers for salt and rinse aid
again
.
2. Adjust the water hardness setting to the
highest setting and perform 1 normal
washing programme
without loading
any
dishes.
3. Adjust the
water
hardness setting
ac-
cording to the hardness of the
water in
your
area.
4. Adjust the rinse aid dosage.
1. Check that the baskets have been
loaded
correctly and that the spray arms are free
to rotate.
2. Check that the
water
tap
is
opened.
Advertisement
