Appendix 7: Installation And Use Of Optional Air Circulation Fan And Thermodisc - Enerzone Solution 1.6 AGENCY PHASE II CERTIFIED WOOD Installation And Operation Manual

Appendix 7: Installation and Use of Optional Air Circulation
Fan and Thermodisc
An optional fan can be installed on the back of the stove to increase the flow of air past heat
exchange surfaces and to help circulate warm air in the room. When used regularly, the fan can
provide a small increase in efficiency, up to 2 percent. However, the use of a fan should not be
used as a way to gain more output from a stove that is undersized for the space it is intended to
heat. You can purchase this option through your ENERZONE dealer. Make sure to specify this part
number: # AC01000
When using the optional fan, allow the stove to reach operating temperature (approximately one
hour), before turning it on. The increased airflow from the fan cools the firebox and could affect the
start-up combustion efficiency if the fan is turned on too early. You can also install the thermodisc
kit, included with your stove, to enable the fan to start or stop automatically when the stove is hot
or too cold. Installation instructions are supplied with the blower and the thermodisc.
Characteristics of the thermodisc:
•
Starts the blower when the stove's temperature reaches 43 °C (110 °F)
•
Cuts the electrical contact when the temperature falls to 32 °C (90 °F).
52
CAUTION: ENSURE THAT THE FAN'S
POWER CORD IS NOT IN CONTACT
WITH ANY SURFACE OF THE STOVE TO
PREVENT ELECTRICAL
FIRE DAMAGE. DO NOT RUN THE
POWER CORD BENEATH THE STOVE.
Solution 1.6 Installation and Operation Manual
SHOCK OR