NEC DT700 User Manual page 24

Table 1.5
1-12
O V E R V I E W
DT700 Series Phones
ITL-2E (DT710 Series) Keys and Parts
1 Call Indicator Lamp
2 Programmable Key
3 Recall key
4 Feature key
5 Redial Key
6 Conf Key
7 Answer key
8 Mic key
9 Message Key
10 Directory Key
11 Hold key
12 Transfer key
13 Speaker key
14 Up/Down Key
The Call Indicator Lamp at top corner of the display flashes
when a call is offered to the phone. Also, if you have Voice Mail
service, the Lamp lights steadily when a message has been
left.
The first programmable key is reserved as the Line Key. Line
Keys allow the user to select which line to operate on.
Any programmable keys not used as Line Keys can be
programmed as Speed Dial Keys by the user or system
administrator. Numbers up to 24 digits can be assigned to
Speed Dial Keys. The numbers may be a telephone number or
star/hash codes.
Sphericall Systems: Press this key to get a dial tone. If you
are currently on a call, the current call will be placed on hold
and a new call will be started.
iS3000-SIP@Net Platforms: See the Hold key.
This key displays a set of menu options that provide additional
capabilities, such as speed dial key programming.
Press this key to redial the last number that was dialed.
Press key to establish a 3-way conference call. The LED on
this key lights when the key is active.
Press this key to answer an incoming call. The audio will go
through the speaker on the phone.
When LED on this key is lit, press key to answer a waiting call.
Press key to mute the microphone. The LED on this key
flashes when the microphone is muted. Press the key again to
un-mute the microphone.
Press key to access the voice mail system.
This key is not currently supported.
Press this key to place a call on hold.
Press this key to transfer a call.
Controls the built-in speaker which can be used for Hands
Free dialing and conversations.
The LED on this key lights when key is active.
Used to adjust various volume levels.
• Handset, Speaker and Headset volume:
Press (UP) or (DOWN) key during conversation.
• Soft Ring Volume:
Press (UP) or (DOWN) key while Soft Ring is playing.
Soft Ring is only available on iS3000-SIP@Net platforms.
Contact your system administrator to determine if Soft Ring is
available on your system.
DT700 User Guide