Atag FG6011C Instructions For Use, Installation, And Connection page 60

Sensors do not
respond, the display
has frozen
The main fuse is tripped
repetitively
Oven interior lighting
does not work
The oven does not heat
up...
The pastry is not
cooked thoroughly...
The program timer
shows extraordinary
fi gures or is turned on
and off uncontrolled
Program timer display is
blinking
The fl ame is uneven /
unstable
The fl ame from the
burners suddenly
changes
The fl ame is
extinguished shortly
after ignition
The grid has
discolored in the
burner area?
Electric ignition of
the burners no longer
works?
60
• Disconnect the cooker from the power network for a few minutes
(remove the fuse or trip the main switch); then, reconnect it to
the power network and turn on the oven.
• Call a service technician!
• The process of replacing the bulb is described on page 59.
• Was the temperature and operating mode selected appropriately?
• Is the oven door closed?
• Did you observe the instructions and tips from the section "Baking
pastry"?
• Did you follow the instructions in the baking table closely?
• In case of faulty operation of the program timer, disconnect the cooker
from the power mains for a few minutes (remove the fuse or trip the
main switch); then, reconnect it to the mains and set the time of day.
• There was a power supply failure, or your cooker was just connected
to the power mains. All set times have been deleted.
• Set the time of day to enable operation of the appliance.
• After the end of program timer controlled operation (automatic
operation), the oven goes off, the time of day is displayed, and an
audible signal is emitted for a certain period of time. Take the dish
out of the oven, return the operation mode selection knob and the
temperature knob/dial back to the starting position.
Have an expert check the gas pipeline!
Assemble the burner correctly.
• Keep the knob depressed for a longer period of time.
• Before releasing it, press it harder.
Clean the grid with a metal care detergent.
Check the fuse in the fuse box and replace it if it is blown.
If the problem persists despite observing the instructions above,
call an authorized service technician. Elimination of any errors or
warranty claims that resulted from improper connection or use of
the appliance is not covered by our warranty. In such cases, the
costs of repair are borne by the user.