Special Warnings And Error Reporting - Atag FG6011C Instructions For Use, Installation, And Connection

Replacing appliance
parts

Special warnings and error reporting

During the warranty period, any repairs may only be performed by service technicians
authorized by the appliance manufacturer.
Before starting the repair, the appliance must be disconnected from the power mains by removing
the fuse or by removing the main cord from the wall outlet.
Unauthorized tampering and repairing may cause the risk of electric shock and short circuit;
therefore, do not attempt to fi x them yourselves. Leave such tasks to an expert or an authorized
service technician.
In case of minor faults or problems with the appliance operation, check the following instructions to
see whether you can eliminate the causes by yourselve.
Important
The oven lamp base and socket are under voltage. There is
a risk of electric shock!
Before replacing the oven lighting bulb, disconnect the cooker
from the power mains by removing the fuses or tripping the main
network switch.
Oven bulb
Oven bulb is considered a replacement ware part and is not
covered by the warranty. Replace the bulb with a new one with
the following specifi cations: socket E 14, 230 V, 25 W, 300°C.
• Unscrew the glass cover in the counterclockwise direction,
replace the bulb, and replace the cover.
A visit by a service technician during the warranty period will be
charged if the appliance is not functioning because of improper
use. Store these instructions in a place where they are always
readily accessible; when passing the appliance on to another
person, the instructions should also be included.
Some advice on rectifying some common problems can be found
in the following:
59