Maintenance
Cleaning the oven interior ceiling
• To facilitate cleaning of the oven interior upper wall, the
appliance features a foldable upper infra heater.
• Before lowering the heater, the cooker must be disconnected
from the power mains by removing the fuse or tripping the
main switch.
• The heater should be cooled down; otherwise there is a risk of
burning!
• Do not use the heater when it is lowered!
Before cleaning the oven, remove the baking trays, the grid, and
the guides. Then, pull the horizontal heater towards yourself. Pull
the heater until the crossbar is released from the supports on the
left and right side of the oven (see fi gure). After cleaning, replace
the heater following the same procedure; the crossbar must be
reinserted into the two support brackets.
Accessories
Wash the accessories (baking trays, grid, etc.) with hot water and
some conventional detergent.
Special enamel coating
The oven, interior side of the door, and baking trays, are covered
with special enamel that has a smooth and resistant surface.
This special layer enables easier cleaning at room temperature.
Removing wire guide racks
To facilitate cleaning of the oven interior side walls, the wire
guide rack can be removed.
• Hold the guide rack by its lower end and rotate it inwards;
then, remove them from the holes on the upper side.
• Clean the guide racks guides only with conventional cleaners.
• After cleaning, simply re-hang the guide rack in the holes
provided and pull downwards.
Removing the inner glass panel
Door glass panes can also be cleaned from the inside; however,
they must fi rst be removed as follows:
• Remove the oven door (see section on removing and inserting
the oven door).
• Hold the door glass pane by its lower edge. Pull it gently
towards yourself and lift it slightly – but not too far – by a
maximum of 10 mm, until the glass support wedge slips out of
fi gure 1
the groove (fi gure 1).
• Remove the glass (in the direction of arrow 3).
57