Main Menu - KVH Industries TracVision G4 Technical Manual

TracVision G4 Technical Manual
Figure 3-5
Main Menu Functions
Select Installed Satellite A
Proceed to Section 3.3,
"Setup Display Mode"
(set data displayed on the LCD
during normal operation)
Proceed to Section 3.4,
"Set Data Outputs Mode"
(set type and format
Proceed to Section 3.5,
"Set Configuration Mode"
(set heading reference source,
enter gyro offsets, reset to factory
defaults, and turn TV comm on/off)
Proceed to Section 3.6,
"Control Compass Mode"
(set calibration, read cal score, and
clear compass calibration)
Proceed to Section 3.7,
"Antenna Status Mode"
(check status and version of
antenna, get antenna serial #, get
signal level & threshold, display skew
angle, and measure bit error rate)
Proceed to Section 3.8,
"Control Antenna Mode"
(adjust antenna azimuth and
elevation manually, restart system,
install satellite pairs, set lat/long,
select active satellite, and update
satellite frequency data)
64

Main Menu

Pressing the center key will cycle the Main Menu through the
available functions as follows:
Setup display type?
Enter
Setup data outputs?
Yes
Setup configuration?
of data outputs)
Yes
Yes
Enter
Enter
Magnetic Heading
###.#°
Next Return
Next Return
Next Return
Control Compass?
Next Return
Get Antenna status?
Next Return
Control antenna?
Next Return
To Factory Default or
Chosen Data Display
Select Installed Satellite B
This menu will only appear
if the heading reference is
configured as INTERNAL.
These menus will not
appear if GyroTrac is
configured to operate as a
stand-alone system (e.g.,
COMM OFF).
54-0147