KVH Industries TracVision G4 Technical Manual page 36

Tips for Safe and Successful Wiring
•
When inserting a wire into a terminal connector,
make certain that the wire insulation is not
pinched in the connector.
•
After inserting and securing wire, tug gently to
ensure that the connection is solid.
•
Position cables behind the ADCU so that they
connect neatly to the terminal strips.
•
Do not tin (solder) the wire ends.
• Each cable provided with the TracVision G4
should be routed and dressed before terminating
at the ADCU. The antenna data and power cable
wires may be trimmed to desired length. However,
be sure to cut back the drain wire (shield); do
NOT connect the drain wire to anything.
Connecting the Antenna Data Cable
Connect the antenna data cable to the red and yellow ADCU
terminal strip connectors as shown in Figure 2-22.
Green/White
White/Green
48 47 46
Orange/White
White/Orange
Gray/White
White/Gray
60 59 58
54-0147
45 44 43 42 41 40 39 38 37
Red Label
57 56 55 54 53 52 51 50 49
Yellow Label
Do NOT connect the antenna data
cable's drain wire (shield).
Figure 2-22
Antenna Data Cable
to ADCU Wiring
Cut back any unused wires from
the Data Cable.
White/Brown
Brown/White
White/Blue
Blue/White
A comprehensive wiring diagram of
the entire TracVision G4 system
has been provided for technical
reference in Appendix D on
page 131 . A color quick reference
guide to wiring the
TracVision G4 is also provided
on the inside front cover of this
manual.
Installation
31