15. When the HPV-20 software and the Ruby application software are
installed, connect the serial cable from the Ruby terminal COM 1 to
the e-PC serial port.
16. Do one of the following:
–
If the Ruby terminal is not plugged in, plug in the terminal.
–
If the Ruby terminal is already running, unplug the square plug
from the power supply. Wait 30 seconds then plug the terminal
back into the power supply. (See figure 8.)
Warning: Do not unplug the round connector from the power
J:\Doc\Frame\HPV20\Graphics\Camera\Power Supply Ruby1 small.bmp
17. When Gemstall has completed, the Ruby terminal boots to the
following display:
Insert HPV-20 Card now and press a key
brick.
Figure 8: Ruby Power Supply
(PRESS A KEY TO CONTINUE)
HPV-20 Installation Guide
2
17