Table of Contents
Advertisement
UpTime is initializing the MSD.
Creating directories...
Copying files...
Setting state to IDLE...
20. The Ruby terminal then continues with its normal boot displays.
Refer to your Ruby reference set for more information on performing
backup, upgrade, restore, and revert functions using the HPV-20
System.
Test after Setup
To make sure the HPV-20 is correctly installed:
Run each Ruby terminal in normal sales mode and verify that the
message "HPV-20 UNAVAILABLE" does not appear on the alarm
line. If this message appears, refer to page 20.
Perform a backup of, at least, the Ruby controller and preferably any
workstations, to test the HPV-20 System.
HPV-20 Installation Guide
2
19
Advertisement
Table of Contents
