Table of Contents
Advertisement
12. Insert the HASP key into the (purple) parallel port. (See figure 6.)
J:\Doc\Frame\HPV20\Graphics\Camera\HASP Hand1.bmp
13. Connect the power supply for the e-PC to the small round connector
in the bottom left corner. (See figure 7.)
J:\Doc\Frame\HPV20\Graphics\Camera\Power to ePC.bmp
14. Install the software in the e-PC by following the steps in "Install the
HPV-20 System Software" on page 20.
16
HPV-20 Installation Guide
Figure 6: HASP Key
Figure 7: e-PC Power Supply
Advertisement
Table of Contents
