Table of Contents
Advertisement
J:\Doc\Frame\HPV20\Graphics\Camera\Null to Ruby.bmp
Figure 3: Null Modem and RS-232 Cable
5. Plug the RJ-45 connector at the other end of the RS-232 cable into
COM 1 on the Ruby controller. (This step may be skipped until the
Ruby controller software is upgraded or installed.)
6. Take the second RS-232 cable and plug it into the second null-modem
adapter. (See figure 4.)
7. Connect the USB-to-serial, 9-pin converter to one
of the (black) USB serial ports on the e-PC.
8. Connect the 9-pin null-modem adapter to the other
end of the 9-pin converter. (See figure 4.)
Note: Do not connect the Ruby terminal to the e-
PC Ethernet port. ALWAYS plug the RS-232
cable into the null-modem adapter and only then plug the
null-modem adapter into the e-PC's serial port.
- USB-to
Serial
HPV-20 Installation Guide
2
13
Advertisement
Table of Contents
