Set Up The Hpv-20 System Hardware - VeriFone HPV-20 Installation Manual

Set Up the HPV-20 System Hardware

The second step in installing the HPV-20 System is to set up the hardware.
The steps that follow use the ports on the e-PC noted in figure 2.
J:\Doc\Frame\HPV20\Graphics\rear with mini text 2.jpg
Figure 2: Rear View of e-PC (Horizontal)
Steps
1. Place the yellow "Warning" label over the Ethernet Connection
located on the back of the e-PC.
2. Using the support stand, place the e-PC on its side with the white
ventilation grid facing up and the dark gray ventilation grid to your
right.
Note: The e-PC operates in this flat position or standing (with the
3. Take one of the RS-232 cables and plug the
RJ-45 connector into the jack of the red, 9-pin
null-modem adapter.
4. Connect the null-modem adaptor into the
(dark green) serial port on the back of the
e-PC. (See figure 3.)
12
HPV-20 Installation Guide
support stand) as shown in figure 1 on page 1.