Bellini CRHR6W01 Installation And User Manual page 7

A: Install against wall
1. Using a spirit level mark a vertical centre line on the wall where the hood is to be positioned, and a horizontal
line where the hood base will be.
NOTE: The distance from the horizontal line to an electrical cooktop underneath must be minimum of
600mm & 650mm to a gas cook top and a maximum height of 750mm.
Minimum:
Electric 600mm
Gas 650mm
Maximum:
750mm
Top of hob
*If the instructions of the hob specify a greater distance than the minimum above, then that shall be the minimum height for installation
2. Drill 4 holes of 8mm diameter on the wall according to below drawing.
Horizontal line
3. Hammer dry wall anchor plugs into holes. Insert 2pcs Screw(ST4x30mm) into the two lower holes(with
distance to horizontal line 496mm) and fasten, they will be used to hang on the range hood.
Warning: Failure to install the screws or fixing device in accordance with these instructions may result in
electrical hazards
Vertical centre line
Horizontal line
Vertical centre line
516mm
496mm
150mm
Where the range hood will be
188mm
Hood base
Hood base
7