Bellini CRHR6W01 Installation And User Manual
Front recirculation range hood & retractable range hood
Hide thumbs
Also See for CRHR6W01:
- User manual (12 pages) ,
- Installation & operation instructions (15 pages)
Advertisement
啊哈
Front Recirculation Range Hood
Retractable Range Hood
Installation and User manual
Content
Safety instructions---------------------------------- 2
Product description--------------------------------- 4
Operation mode-------------------------------------- 5
Installation--------------------------------------------- 6
Start using the range hood------------------------ 10
Maintenance and cleaning-------------------------11
Warranty------------------------------------------------ 12
For warranty service call 1300 373 199(Australia)
or 0508 123108(New Zealand) to connect you to
the nearest authorised service centre
&
20121212 issue 5
CRHR6W01
CRHR6W01-F
1
BR603FRW
BR603FRW-F
Advertisement
Related Manuals for Bellini CRHR6W01
Summary of Contents for Bellini CRHR6W01
-
Page 1: Table Of Contents
Product description--------------------------------- 4 Operation mode-------------------------------------- 5 Installation--------------------------------------------- 6 Start using the range hood------------------------ 10 Maintenance and cleaning-------------------------11 Warranty------------------------------------------------ 12 CRHR6W01 For warranty service call 1300 373 199(Australia) CRHR6W01-F or 0508 123108(New Zealand) to connect you to BR603FRW the nearest authorised service centre... -
Page 2: Safety Instructions
Safety Instructions This manual explains the proper installation and use of your range hood, please read it carefully before using even if you are familiar with the product. The manual should be kept in a safe place for future reference. Never to do: Always to do: This appliance is not intended for use by persons... - Page 3 Safety Instructions Never to do: Always to do: This range hood cannot be installed for outdoor use. Attention should be given to ensure that any It is prohibited to fit the range hood over a solid fuel applicable regulations concerning discharge stove of exhaust air are fulfilled.
-
Page 4: Product Description
Product Description Accessories bag Description Picture Installation & User Manual Metal plate L bracket Outlet( diameter 120mm) Dry wall anchors plugs Screw (M4x10mm) Screw(ST4x30mm) Screw (ST3x12mm)* Washer* Screw (M4x35mm)* *Used in installation method B Component list: Technical data: 1. L bracket(used installation A method) 2. -
Page 5: Operation Mode
Operation Mode Your range hood can be operated in two optional modes, choose the mode suitable for your kitchen before installation. Air Exaction For air exaction mode, a ducting kit is required, the air is drawn in and cleaned by the grease filters and directed outside. -
Page 6: Installation
Installation Dimensions: CRHR6W01, CRHR6W01-F BR603FRW, BR603FRW-F Installation: Warning: Check that the installation complies with the standards of local building, gas and electrical authorities. Before connecting to the mains supply ensure the mains voltage corresponds to the voltage on the appliance rating plate inside the range hood. - Page 7 A: Install against wall 1. Using a spirit level mark a vertical centre line on the wall where the hood is to be positioned, and a horizontal line where the hood base will be. NOTE: The distance from the horizontal line to an electrical cooktop underneath must be minimum of 600mm &...
- Page 8 Fit the outlet and flexible exhaust pipe on top of range hood body. 4. Hang on the range hood, fasten 2pcs Screw(ST4x30mm) and L bracket onto two higher holes(with distance to horizontal line 516mm), and then fasten 2pcs Screw (M4x10mm) and L bracket onto body. Warning: Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards B: Install into cabinet...
- Page 9 2. Fit the outlet on top of range hood body. 3. Install the range hood onto the bottom of cabinet board, fasten 6pcs Screw (M4x35mm) with washers. If gap is there between range hood back and cabinet end, fasten 2pcs Screw (ST3x12mm) and metal plate onto body to fill it.
-
Page 10: Start Using The Range Hood
Start Using Your Range Hood ○ ○ Speed –select speed to suit cooking conditions Lamp – Turn on/off light “O” – to switch off motor “O” – to switch off light Low( )– light frying/boiling “ ” – to switch on light ) –... -
Page 11: Maintenance And Cleaning
Maintenance and cleaning Caution: • Before maintenance or cleaning is carried out, the GREASE MESH FILTERS range hood should be disconnected from the main The mesh filters can be cleaned either by hand or in power supply. Ensure that the range hood is switched the dishwasher. -
Page 12: Warranty
Consumer until the expiry of two (2) years (Warranty Period). If within the Warranty Period a manufacturing defect is discovered in the Bellini product or it fails to perform to the Company’s specifications as a result of some defect in materials, components or workmanship (Defect) then the Company will, at its option, repair the Bellini product or supply a replacement Bellini product free of charge. - Page 13 1.10 If you are required to transport the Bellini product to the Company or its service agent, you must ensure it is safely disconnected by a qualified tradesman and securely packed and insured. The Company does not accept any responsibility for loss or damage of the Bellini product prior to it being received by the Company or its service agent.