Advertisement
File No.
960-010
3.11
HARD DISK TEST
CAUTION:
The contents of the hard disk will be erased when
subtest 02, 03, 04, 06, 08, 09, or 10 is run. Before running
the test, transfer the contents of the hard disk on the
floppy disk. This can be done with the MS-DOS BACKUP command.
After the test, enter the MS-DOS FDISK command, which will
set the partition. Then enter the MS-DOS FORMAT command.
(See
the MS-DOS manual for details.)
OPERATION
1.
When you select the hard disk test of the DIAGNOSTIC TEST
MENU, the following message will appear.
Test drive number select (1:HDD1,2:HDD2,O:HDD1&2) ?
2.
Select the drive number of the hard disk to be tested and
press the Enter. The following message will appear.
HDC F/W error retry
(1:yes,2:no) ?
3.
This message is used to select whether to do retry operation
or not when the hard disk controller detects an error.
Select yes or no and press the Enter. The following message
will appear.
Data compare error dump
(1:no,2:yes)?
4.
This message is used to select whether to do dump operation
or not when data compare error is detected.
Select yes or
no and press the Enter. The following message will appear.
Detail status display
(1:no,2:yes) ?
5.
This message is used to select whether to display the detail
status on the screen or not.
The detail status are
described in section 3.16. Select yes or no and press the
Enter.
3-22
Advertisement
