Advertisement
File No.
960-010
4 .9
POWER SUPPLY UNIT
WARNING:
Pay attention to handling the power supply unit to
which high voltage is supplied.
Note that it will take a
few minutes to discharge the electricity after power-off.
1.
Remove the keyboard, PDP mask, PDP unit, LED board and
PDP cover with top cover according to sections 4.2 and
4.4 through 4.8.
2.
Disconnect a connector (A) from the power supply board
(PJ4) .
3.
Remove the power supply unit (B) by removing 5 screws
(e), lift up it, then disconnect the connecter (D) from
the system board (PJ7).
(C)
~.>r---(A)
(0)
Figure 4-14
Power supply unit
4.
Reverse procedure to install.
4-15
Advertisement
