Advertisement
File No.
960-010
5.
Select a subtest. Type in the subtest number, then press
Enter. The following message will appear:
TEST LOOP (1:YES/2:NO)
?
NOTE:
If you select KEYBOARD TEST, this message will not
appear.
If you select YES (by typing in 1, then pressing Enter) :
Each time a test cycle ends, it increments the pass counter
by one and repeats the test cycle.
If you select NO (by typing in 2, then pressing Enter) :
At the end of a test cycle, the test execution is terminated
and you exit to the subtest menu.
6.
Type in 1 or 2, then press Enter. The following message will
appear:
ERROR STOP (1:YES/2:NO)
?
If you select YES (by typing in 1, then pressing Enter) :
When an error occurs, the error status is displayed and
execution of the test program stops and the operation guide
is displayed on the right side of the display screen.
If you select NO (by typing in 2, then pressing Enter) :
When an error occurs, the error status is displayed then the
error counter is incremented by one and you can continue the
test.
7.
Type in 1 or 2, then press Enter and the test program will
run. Each subtest is described in section 3.3.
8.
When an error occurs during the test program, the following
message will appear:
(if you answer YES for ERROR STOP
question, )
ERROR STATOS NAME
[[ HALT OPERATION ]]
1: Test End
2: Continue
3: Retry
1: Terminates the test program execution and exits to the
subtest menu.
2: Continues the test.
3: Retires the test.
The error code and error status names are described in
section 3.15.
3-4
Advertisement
