Advertisement
File No.
960-010
3.8
FLOPPY DISK TEST
CAUTION:
Before running the floppy disk test, prepare a
formatted work disk and remove the diagnostics disk.
Then insert
the work disk into the FDD.
Because the contents of the floppy
disk will be erased.
OPERATION
1.
When you select the floppy disk test of the DIAGNOSTIC TEST
MENU, the following message will appear under the DIAGNOSTIC
TEST MENU.
Test drive number select (1:FDD1,2:FDD2,O:FDD1&2)
?
2.
Select the test drive number, then press the Enter. The
following message will appear.
Media in drive#l mode
(O:2DD,1:2D,2:2D-2HD/2DD,3:2HD) ?
3.
Select the media type of the floppy disk to be tested, then
press the Enter. The following message will appear.
Test start track (Enter:O/dd:OO-79) ?
4.
You can select the start track number of the floppy disk
test.
When pressing the Enter only, the start track number will be
zero.
If you desire, select the start track number.
Then the
subtest menu of the floppy disk test will appear.
5.
During the floppy disk test, the message shown below will
appear. The ADDRESS number indicates that the first XX shows
a cylinder number, the third X shows a head number, and the
last XX shows a sector number.
The STATUS number indicates that the first X shows a drive
number and the last XX shows an error status code.
FLOPPY DISK
SUB-TEST
PASS COUNT
WRITE DATA
ADDRESS
XX
XXXXX
XX
XXXXX
ERROR COUNT
READ DATA
STATUS
3-16
xxxxxxx
xxxxx
XX
XXX
Advertisement
