Advertisement
File No.
960-010
PROCEDURE 4
Hard Disk Test Execution
CAUTION:
The contents of the hard disk will be erased when
the test program is run. Before running this test, transfer
the contents of the hard disk to floppy disks. This can be
done with the MS-DOS BACKUP command.
(See the MS-DOS Manual
for details.)
1.
Insert the diagnostics disk into the FDD and load the
test and diagnostics programs.
2.
Run the hard disk test as indicated on the diagnostic
test menu.
3.
If an error is detected during the hard disk test, an
error code and status will be displayed; go to
PROCEDURE 6.
The error codes are described in table 2-
5.
4.
If no error is generated, the HDD is normal. Enter the
MS-DOS FDISK command to make partition of the hard
disk.
Then enter the MS-DOS FORMAT command.
(See the
MS-DOS Manual for details.)
Code
01
02
04
05
07
09
OA
OB
10
11
20
40
80
AA
BB
CC
EO
Fa
Table 2-5
HDD error code
Status
Bad command error
Bad address mark
Record not found
HDC not reset
Drive not initialize
DMA boundary error
Bad sector error
Bad track error
ECC error
ECC recover enable
HDC error
Seek error
Time out error
Drive not ready
Undefined
Write fault
Status error
Not sense error CHW.code=FF)
2-28
Advertisement
