Advertisement
File No.
960-010
4 . 10
POWER SUPPLY COVER
1.
Remove the keyboard, PDP mask PDP unit, LED board, PDP
cover with top cover and power supply unit according to
sections 4.2 and 4.4 through 4.9.
2.
Remove the screw and washer assemblies (A) while
lifting the power supply cover (B) slightly.
3.
Remove the power supply cover by disengaging from 3
tabs (C) on the power supply base (D).
Figure 4-15
Power supply cover
4.
Reverse procedure to install.
NOTE:
In case of installing, place the power supply cover
between the power supply base and the installing plate (E)
and slide, then attach with screws after tabs enter.
4-16
Advertisement
