Usb3.0 Connectors (Usb10/Usb11/Usb12/Usb13)(J15/J15/J14/J14) - Kontron KTA70M/mITX User Manual

KTD-N0861-B
6.2

USB3.0 Connectors (USB10/USB11/USB12/USB13)(J15/J15/J14/J14)

The USB3.0 connectors are based on standard USB3.0 connectors type Lotes ABA-USB-104-K01 or similar.
Thease 4 USB3.0 ports are controlled by the xHCI controllers supporting USB3.0, USB2.0 and USB 1.1,
Super-Speed (5.0Gbps), High-Speed (480Mbps), Full-Speed (12Mbps) and Low-Speed (1.5Mbps)
USB Ports 10 and 11 (mounted on top of the DP#2 port):
Note Type
DSIO-3.3
1 PWR
DSIO-3.3
DSIO-3.3
PWR
DSIO-3.3
1 PWR
DSIO-3.3
DSIO-3.3
PWR
Signal Description
USB10+ USB10-
RX10+ RX10-
TX10+ TX10-
Differential pair works as Data/Address/Command Bus.
USB11+ USB11-
RX11+ RX11-
TX11+ TX11-
5V supply for external device. SB5V is supplied during powerdown to allow wakeup on
5V/SB5V
device activity. Protected by current limited power distribution switch,1A for each port.
USB Ports 12 and 13 (mounted on top of the DP#0 port):
Note Type
DSIO-3.3
1 PWR
DSIO-3.3
DSIO-3.3
PWR
DSIO-3.3
1 PWR
DSIO-3.3
IO
PWR
Page 18
Signal PIN
USB10- USB10+
5V/SB5V 1 2 3
RX10- 5 6 7 8
RX10+ TX10-
GND
USB11- USB11+
5V/SB5V 1 2 3
RX11- 5 6 7 8
RX11+ TX11-
GND
Signal PIN
USB12- USB12+
5V/SB5V 1 2 3
RX12- 5 6 7 8
RX12+ TX12-
GND
USB13- USB13+
5V/SB5V 1 2 3
RX13- 5 6 7 8
RX13+ TX13-
GND
KTA70M/mITX Users Guide
KTA70M/mITX Users Guide
Signal Type
DSIO-3.3
4 GND PWR
9 TX10+ DSIO-3.3
DSIO-3.3
DSIO-3.3
4 GND PWR
9 TX11+ DSIO-3.3
DSIO-3.3
Signal Type
DSIO-3.3
4 GND PWR
9 TX12+ DSIO-3.3
DSIO-3.3
DSIO-3.3
4 GND PWR
9 TX13+ DSIO-3.3
DSIO-3.3
Rear IO Connectors
Note
Note