About Dvb-Asi Input/Output (When The Optional Pdbk-202 Is Used) - Sony XDS-PD1000 Operation Manual

Notes
• Always make a test recording, and verify that it was
recorded successfully. SONY WILL NOT BE
LIABLE FOR DAMAGES OF ANY KIND
INCLUDING, BUT NOT LIMITED TO,
COMPENSATION OR REIMBURSEMENT ON
ACCOUNT OF FAILURE OF THIS UNIT OR ITS
RECORDING MEDIA, EXTERNAL STORAGE
SYSTEMS OR ANY OTHER MEDIA OR
STORAGE SYSTEMS TO RECORD CONTENT
OF ANY TYPE.
• Always verify that the unit is operating properly
before use. SONY WILL NOT BE LIABLE FOR
DAMAGES OF ANY KIND INCLUDING, BUT
NOT LIMITED TO, COMPENSATION OR
REIMBURSEMENT ON ACCOUNT OF THE
LOSS OF PRESENT OR PROSPECTIVE PROFITS
DUE TO FAILURE OF THIS UNIT, EITHER
DURING THE WARRANTY PERIOD OR AFTER
EXPIRATION OF THE WARRANTY, OR FOR
ANY OTHER REASON WHATSOEVER.
About DVB-ASI Input/
Output (When the
Optional PDBK-202 Is
Used)
When the optional PDBK-202 MPEG TS board is
installed, you can input/output DVB-ASI TS signals via
this connector.
Note
Even when the PDBK-202 is installed, this unit does not
allow for input/output of i.LINK TS signals.
Stream formats
The stream formats of DVB-ASI TS signals that can be
input to / output from this unit are listed below.
Notes
• This unit does not allow for input/output of DVB-ASI
TS signals in any format other than listed below.
• Set the program number for DVB-ASI TS of this unit so
as to match that of a device from which DVB-ASI TS
signals are input to this unit or a device to which DVB-
ASI TS signals are output from this unit. The program
number for DVB-ASI TS can be set with the setup menu
item 926 DVB-ASI SETTING (see page 87).
Video resolution/system frequency
1440 × 1080/59.94i, 50i, 29.97P, 25P
1920 × 1080/59.94i, 50i, 29.97P, 25P
1280 × 720/59.94P, 50P
Note
When the system frequency is 23.98P, input/output of
DVB-ASI TS signals is impossible.
Video codec
MPEG-2 MP@HL (manual mode)
MPEG-2 MP@H-14 (HDV-compliant mode)
Audio codec
MPEG-1 Layer2: 2 channels, 48 kHz, 384 kbps
MPEG-2 Layer2: 4 channels, 48 kHz, 384 kbps
Auxiliary packet
AUX1, AUX2: For HDV-compliant mode
When in manual mode, metadata can be output to the
AUX1 packet.
Bit rate selection range
15.00 Mbps to 43.25 Mbps (in steps of 0.01Mbps)

About DVB-ASI Input/Output (When the Optional PDBK-202 Is Used)

111