Sony XDS-PD1000 Operation Manual page 27

(showing that this unit is in the standby state), and then
press the main power switch to the off side.
b AC power input connector (-)
Connect to an AC power supply with the power cord (not
supplied).
c Ground terminal (U)
Connect this to ground as required.
4 Digital audio signal input/output
section
1 DIGITAL AUDIO (AES/EBU) IN 1/2, 3/4, 5/6,
7/8 connectors
2 DIGITAL AUDIO (AES/EBU) OUT 1/2, 3/4, 5/6,
7/8 connectors
a DIGITAL AUDIO (AES/EBU) IN (digital audio
input) 1/2, 3/4, 5/6, 7/8 connectors (BNC type)
These input AES/EBU format digital audio signals.
b DIGITAL AUDIO (AES/EBU) OUT (digital audio
output) 1/2, 3/4, 5/6, 7/8 connectors (BNC type)
These output AES/EBU format digital audio signals.
To treat the input and output signals of these connectors as
non-audio signals, set the maintenance menu item M37:
AUDIO CONFIG >M372: NON-AUDIO INPUT
(recording) (see page 93).
5 Analog audio signal input/output
section
1 ANALOG AUDIO INPUT 1, 2 connectors
2 ANALOG AUDIO OUTPUT 1, 2
3 AUDIO MONITOR OUTPUT R, L connectors
connectors
a ANALOG AUDIO INPUT 1, 2 connectors (XLR 3-
pin, female)
These input analog audio signals.
With A1 INPUT to A4 INPUT on page P1 INPUT (see
page 42) and A5 INPUT to A8 INPUT on page P2 INPUT
of the function menu, you can assign the signal input to
connector 1 to an odd numbered channel (1, 3, 5 or 7), and
assign the signal input to connector 2 to an even numbered
channel (2, 4, 6 or 8).
You can set the reference input level with the maintenance
menu item M37: AUDIO CONFIG (see page 93). (Factory
default setting: +4 dB)
b ANALOG AUDIO OUTPUT 1, 2 connectors (XLR
3-pin, male)
These output analog audio signals.
When the unit is shipped from the factory, the connector 1
is set to audio channel 1, and the connector 2 is set to audio
channel 2. You can change these settings with setup menu
item 824 ANALOG LINE OUTPUT SELECT (see
page 86).
You can set the output level with the maintenance menu
item M37: AUDIO CONFIG (see page 93). (Factory
default setting: +4 dB)
Non-audio signals are muted.
c AUDIO MONITOR OUTPUT R, L connectors
(XLR 3-pin, male)
Output audio signals for monitoring.
The monitored channel is selected with MONITR L and
MONITR R on the HOME page of the function menu.
Output signals are E-E signals or playback signals,
according to the setting of the REC PORT and PB PORT
buttons on the front panel.
See "Basic Operations of the Function Menu" (page 41)
for more information about the MONITR L and MONITR
R settings.
27
Rear Panel