Chase Copy - Sony XDS-PD1000 Operation Manual

To perform deletion, insert the desired memory card
into the ExpressCard slot of a computer or into an SxS
memory card reader connected to a computer, and use
XDCAM Browser or other appropriate application
software.
To copy clips on an SxS memory card to a
Professional Disc
Insert the copy source SxS memory card into the card slot,
and insert the copy destination Professional Disc into the
disc slot. Then carry out the procedure described in
"Copying clips on an SxS memory card/Professional Disc
to the internal storage" (page 54).
Note that in step 7 of that procedure, it is necessary to
select a combination of SxS memory card as copy source
and Professional Disc as copy destination.
To copy clips on the internal storage to a
Professional Disc
Insert a Professional Disc into the disc slot, and carry out
the procedure described in "Copying clips on an SxS
memory card/Professional Disc to the internal storage"
(page 54).
However, note that the following is different.
• In step 3, press the INTERNAL button.
• Pass by steps 6 and 7. (When the copy source media is
the internal storage, you cannot select "ALL".)
To copy an EDL file
An EDL can be copied by an operation similar to a clip
copy operation. However, it is necessary to make a copy of
all clips referenced by the EDL in advance. Therefore,
when the copy source media is an SxS memory card /
Professional Disc, "ALL" is automatically selected in step
6 of the procedure for "Copying clips on an SxS memory
card/Professional Disc to the internal storage" (page 54).
To copy the specified part of a clip
When you set an IN and OUT point in the clip, it becomes
possible to copy only the part defined by the IN and OUT
points.
Note
You cannot make a partial copy of clips on an SxS memory
card.
1
In the video monitor screen, cue the clip up to the
frame where you want set an IN point.
2
Press the PUSH SET knob while holding down the left
arrow button.
56
Copying
An IN/OUT setting window appears in the bottom
right corner of the display.
The IN point timecode is displayed in the IN/OUT
setting window, and the IN indicator lights.
3
Cue up to the frame where you want to set an OUT
point.
4
Press the PUSH SET knob while holding down the
right arrow button.
An IN/OUT setting window appears in the bottom
right corner of the display.
The OUT point timecode and the duration (DUR) are
displayed in the IN/OUT setting window, and the OUT
indicator lights.
5
Carry out step 5 and following of the procedure for
"Copying clips on an SxS memory card/Professional
Disk to the internal storage".
To delete the IN/OUT points
1
Press the left arrow button (or right arrow button).
The IN/OUT setting window appears in the bottom
right corner of the display.
2
Press the RESET button.
The IN (or OUT) indicator turns off.
Note
One of the following operations deletes the IN/OUT points
automatically.
• Change the selection of media.
• Remove the media.
• Delete the clip in which IN/OUT points are set.
• Format the media.

Chase copy

When a clip is being recorded to the internal storage, that
clip can also be copied to the Professional Disc at the same
time.
1
Carry out the procedure described in"Carrying out
recording" (page 48) to start recording to the internal
storage.
2
Press the THUMBNAIL button to display a clip list
screen.
3
Select the clip that is being recorded.
4
Press the COPY button.