Playback - Sony XDS-PD1000 Operation Manual

Frame frequency
50 Hz
23.98 Hz
Notes
• When the unit is in a mode that calls for playback across
clips that were recorded in different recording formats,
video and audio playback may stop at the point where
the format changes from one format into another, and
then start again.
• If a transition point between two clips with different
recording formats exists in the preroll segment, that
segment cannot be edited.
50

Playback

System frequency
50P
50i
25P
23.98P
Playback
This section describes playback of video and audio on the
unit.
Before starting playback, make the following settings and
adjustments.
Selection of time data to display: Select with CNTR SEL
on HOME page of the function menu.
Selection of audio channels to monitor: Select with
MONITR L and MONITR R on the HOME page of
the function menu.
Volume adjustment of the monitor audio: Adjust with
the LEVEL adjustment knob.
Playback target (when playing back clips/
EDLs on the internal storage)
Only the currently selected clip/EDL on the internal
storage is played back.
The available playback types include normal playback,
high-speed playback in the forward or reverse directions,
and jog, shuttle, and variable-speed playback. Playback
stops when it reaches the start or end of the clip/EDL. The
next and preceding clips are not played, even if they exist
on the media.
To move to another clip, press the PREV, NEXT, SHIFT
+ PREV, or SHIFT + NEXT button, or perform a
thumbnail search.
About the playback start position
Immediately after this unit starts
All clips are closed. To play a clip or an EDL, select it in a
clip list screen.
After disc insertion
The unit stops at the position of the disc when it was most
recently ejected.
Press the PLAY button to resume playback at the most
recent position.
The playback position is saved to the disc when the disc is
ejected, which allows playback to start at that position
whenever it is loaded into any XDCAM player.
Notes
• This function is not available when the Write Inhibit tab
of the disc is set to the recording disabled position.
When the Write Inhibit tab is in the recording enabled
position and the format of recorded sections on the disc
is not the same as the recording format setting of this
unit, the REC INHI indicator lights, but in this case the
playback position is saved to the disc.
• When playback is stopped on an EDL, the playback
position is not saved.