List Of Port Numbers Used On The Pcs-11/11P - Sony PCS-11 Operating Instructions Manual

Pin Signal Description
3 TA Transmit+
4 RA Receive+
5 RB Receive–
6 TB Transmit–
7 NC –
8 NC –
TERMINAL connector
B384S/PCS-B384/PCSA-B768S/
PCS-B768)
2
1
USB connector
Pin Signal Description
1 GND Chassis ground
2 19.5V 19.5V
3 DCLK+ Clock+
4 DCLK– Clock–
5 DR+ Transmit data+
6 DR– Transmit data–
7 FS+ Frame sync+
8 FS– Frame sync–
9 DX+ Receive data+
10 DX– Receive data–
11 TX Serial transmit data
12 RX Serial receive data
13 19.5V 19.5V
14 GND Ground
(PCSA-
14
13
List of Port Numbers Used on
the PCS-11/11P
When connecting one-to-one
(Default)
When "Port Number Used" is set to
"Default" in the LAN Setup menu, the PCS-
11/11P uses the following port numbers.
Signal Port number
RAS (PCS-11/ Any number from 2253
11P) to 2255 (using
GateKeeper)
RAS 1718 or 1719 (using
(GateKeeper) GateKeeper)
Q.931 (dial) Any number from 2253
to 2255
Q.931 (answer) 1720
H.245 Any number from 2253
to 2255
Audio RTP 49152
Audio RTCP 49153
Video RTP 49154
Video RTCP 49155
FECC RTP 49156
FECC RTCP 49157
Data conference 49158
RTP
Data conference 49159
RTCP
When connecting one-to-one
(Custom: TCP Port Number 3000
and UDP Port Number 3000)
When "Port Number Used" is set to
"Custom" in the LAN Setup menu, the PCS-
11/11P uses the port numbers defined by the
values entered in "TCP Port Number" and
"UDP Port Number".
For example, when "TCP Port Number" is
set to "3000" and "UDP Port Number" is set
199
Specifications