Accessing The Network Camera - Brickcom Hydra Series Hardware User's Manual

Accessing the Network Camera

Check Network Settings
The camera can be connected either before or immediately after the software
installation. The Administrator should complete the network settings on the
configuration page, including entering the correct subnet mask, IP address of gateway,
and DNS. Ask the network administrator or Internet service provider for the detail
information.
Add the Password to Prevent Unauthorized Access
The administrator should immediately implement a new password as a matter of
prudent security practice. For the first time, the username and password for the
administrator are assigned as "admin/admin". After the administrator changes the
administrator password, the web browser will display an authentication window to
confirm the new password. Once the password is set, there is no provision to recover
the administrator's password. If the administrator's password is lost, please reset to the
original factory default settings.
The administrator can be set up a maximum of ten user accounts. Users will be able to
access the network camera, but will not be allowed to access system configurations.
30