Table of Contents
Advertisement
INSTAllATION
CONNECTiNg ThE gROuNd
The nut and ground terminal on the generator should always
be used to connect the generator to a suitable ground. The
ground cable should be #8 size wire (aluminum) minimum. If
copper wire is used, #10 size wire minimum should be used
At the generator, connect the terminal of the ground cable
between the lock washer and the nut (Figure 3) and tighten
the nut fully. Connect the other end of the ground cable to
a suitable earth ground (ground rod).
GROUND CABLE
(#8 MINIMUM)
GROUND ROD
FOR EARTH GROUND
CONNECT TO
GENERATOR
BUILDING GROUND
GROUND LUG
IF REQUIRED
8 FT.
MINIMUM
REFERENCE
NEC 250-52(C)
Figure 3. Generator Grounding
pAgE 16 — ga3.6HR 60 hz gENERATOR• OpERATiON ANd pARTs mANuAl — REv. #0 (09/17/14)
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the GA3.6HR and is the answer not in the manual?
Questions and answers