Table of Contents
Advertisement
SmartNode 4660 & 4670 User Manual
The SmartNode supports two configuration options for the Ethernet connection (see
in the following paragraphs:
•
DHCP (client—factory default). The SmartNode's WAN port has a DHCP client enabled that uses an
established Internet connection to get the Internet connectivity parameters (IP address, default gateway)
automatically from a DHCP server. Use this option when connecting the SmartNode to a DSL router, a
cable modem, or to a company LAN (with a DHCP server). This is the factory default configuration so no
configuration is required, only the LAN and WAN Ethernet connections should be made to access the
Internet immediately.
•
User Defined Address. The SmartNode uses an existing internet connection which does not provide an
upstream DHCP server. In this case, you need to set the IP address, subnet mask, default gateway and
DNS servers manually.
-
IP Address—The IP address of the WAN Ethernet port.
-
IP Mask—The mask for the WAN port's IP address.
Click the Apply icon to activate the new configuration.
Configuring your SmartNode
Figure 11. Ethernet Configuration page
4 • SmartNode initial configuration
figure
11), as described
34
Advertisement
Table of Contents
