SmartNode 5300 User Manual
1. Connect the 10/100 Base-T Ethernet LAN and WAN (see section
net LAN and WAN cables"
2. If applicable, connect the DSL WAN port (see section
3. Connect the power mains cable (see section
Connecting the 10/100 Base-T Ethernet LAN and WAN cables
The SmartNode has automatic MDX (auto-crossover) detection and configuration on all Ethernet ports. Any
of the ports can be connected to a host or hub/switch with a straight-through or cross-over wired cable.
1. Connect to the subscriber port of the broadband access modem (DSL, cable) to ETH 0/0. (The behavior
of the physical Ethernet port can be configured, to be used as either LAN, WAN, or DMZ interface).
This SmartNodes supports full and half duplex mode. For best results, use
Note
auto-negotiation.
2. Connect port ETH 0/1 to your LAN. (The behavior of the physical Ethernet port can be configured to be
used as either LAN, WAN, or DMZ interface).
For details on the Ethernet port pinout and cables, refer to
D, "Port Pin-outs"
on page 34.
Installation cable requirements
The following cable requirements are for the DSL WAN cable (SN5300/4B2G/EUI and
SN5300/4B4G/EUI only).The SN5300/4B2G/EUI and SN5300/4B4G/EUI comes with a universal option
for a G.SHDSL-EFM/ATM interface. Use a straight-through RJ-45 cable to connect the G.SHDSL-EFM/ATM
port.
Connecting the power supply
The 5300 has an
External AC Power
External AC Power Supply.
WARNING
1. Insert the female end of the AC power to the mains port.
Installing the SmartNode
on page 13)
"Connecting the power supply"
Supply, see
figure
•
Do not connect power to the AC Mains at this time.
•
There are no user-serviceable parts in the power supply section
of the Model 5300. Contact Patton Electronics Technical sup-
port at (301)975-1007, via our web site at http://www.pat-
ton.com, or by e-mail at support@patton.com, for more
information.
"Connecting the 10/100 Base-T Ether-
"Installation cable requirements"
Appendix C, "Cabling"
8.
3 • SmartNode Installation
on page 13)
on page 13)
on page 31 and
Appendix
13