SmartNode 4660 & 4670 User Manual
Installing the SmartNode
SmartNode hardware installation consists of the following:
•
Placing the device at the desired installation location (see section
•
Connecting the interface and power cables (see section
When you finish installing the SmartNode, go to chapter 4,
Placing the SmartNode
Place the SmartNode on a desktop or similar sturdy, flat surface that offers easy access to the cables. The unit
should be installed in a dry environment with sufficient space to allow air circulation for cooling.
Note
For proper ventilation, leave at least 2 inches (5 cm) to the left, right, front,
and rear of the unit.
Ground connection
Installing cables
Connect the cables in the following order:
1. Connect the ISDN terminals to the BRI ports (see section
SmartNode's ISDN BRI ports"
2. Installing the RJ-11 voice port (FXS or FXO) cables (see section
SmartNode's FXS and FXO interface ports"
3. Connect the 10/100Base-T Ethernet WAN (see section
on page 27)
4. For SN4671 models, connect the DSL cable (see section
(SN4670 series only)"
5. Connect the power supply (see section
Installing the SmartNode
To be compliant with safety regulations (EN60950-1, UL60950-
1 and CAN/CSA-C22.2 No 60950), the ground terminal must
be connected to a reliable ground.
Do not work on the system or connect or disconnect cables during periods of
lightning activity.
on page 27).
on page 27)
on page 27)
"Connecting the SmartNode to the power supply"
3 • SmartNode installation
"Placing the
SmartNode")
"Installing
cables")
"SmartNode initial configuration"
"Connecting ISDN terminals and NT to the
"Installing an interface cable on the
"Connecting the SmartNode to the IP network"
"Connecting the SmartNode's DSL port
on page 29.
on page 28)
26