SmartNode 4660 & 4670 User Manual
Port
12V DC, 1.0A
Reset
SmartNode 4670 front panel
The LED definitions are listed in
LED
Power
SmartNode 4670 Ports and LEDs
Table 6. SN4670 rear panel ports (Continued)
The SmartNode has a 12V DC 1A power input (see
The reset button (see
Restart the unit with the current startup configuration—Press (for less than 1
•
second) and release the Reset button to restart the unit with the current star-
tup configuration.
•
Restart the unit with factory default configuration—Press the Reset button
for 5 seconds until the Power LED starts blinking to restart the unit with fac-
tory default configuration.
Restart the unit in bootloader mode (to be used only by trained SmartNode
•
4660 technicians)—Starting with the unit powered off, press and hold the
Reset button as you apply power to the unit. Release the Reset button when
the Power LED starts blinking so the unit will enter bootloader mode.
table
5.
Table 7. SmartNode 4670 LED definitions
When lit, indicates power is applied and the unit is in normal operation. Off indi-
cates no power applied. Flashes once per second during boot (startup).
Description
) has three functions:
figure 2
Description
1 • General information
).
figure 2
20