Table of Contents
Advertisement
SmartNode 4980 & 4990 User Manual
Connect the cables in the following order:
1. Connect the T1/E1 cables to the PRI T1/E1 ports (see
page
55).
2. Connect the 10/100/1000Base-T Ethernet LAN and WAN (see section
10/100/1000Base-T Ethernet LAN and WAN cables"
3. Connect the power mains cable (see section
Connecting the PRI
The SmartNode comes with one or four PRI ports. These ports are usually connected to a PBX or switch (local
exchange (LE) ). Each PRI T1/E1 port is a RJ-48C receptacle. In most cases, a straight-through RJ-45 can be used
to connect the PRI. Each port can be configured as NT (clock master) or TE (clock slave).
For details on the PRI port pin-out and ISDN cables, refer to Appendix C, "Cabling" on page 43 and Appen-
dix D, "port pin-outs" on page 47.
Connecting the 10/100/1000Base-T Ethernet LAN and WAN cables
The SmartNode has automatic MDX (auto-crossover) detection and configuration on all Ethernet ports. Any
of the ports can be connected to a host or hub/switch with a straight-through or cross-over wired cable.
1. Connect to the subscriber port of the broadband access modem (DSL, cable, WLL) to ETH 0/0.
Note
The SmartNode Ethernet ports operate in Full Duplex mode only. Do not
connect to Half Duplex ports. For best results, use auto-negotiation. Auto
negotiation is mandatory when using 1000BaseT (Gigabit) Ethernet.
2. Connect port ETH 0/1 to your LAN.
For details on the Ethernet port pinout and cables, refer to
D, "Port pin-outs"
on page 55.
Installing the DSL WAN cable (SN4991 /2GS Models)
The SmartNode Model 4991 comes with an option for a G.SHDSL or ADSL WAN interface. Use a straight-
through RJ-45 cable to connect the G.SHDSL port.
For details on the G.SHDSL port pinout, refer to
Installing the X.21 WAN cable (SN4991 /D Models)
The SmartNode Model 4991 comes with an option for an X.21 serial interface. Insert the X.21 WAN cable's
DB-15 male end into the DB-15 connector on the SN4991. Plug the other end of the cable into the X.21
device.
For details on the X.21interface pinout, refer to
Installing the SmartNode
The interconnecting cables shall be acceptable for external use
and shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
"Connecting the power supply"
"G.SHDSL port (/2GS models only)"
"X.21 DB-15 connector (/D models only)"
3 • SmartNode installation
Appendix C on page 50
"Connecting the
on page 29)
on page 30)
Appendix C, "Cabling"
and
Appendix D on
on page 50 and
Appendix
on page 57.
on page 58.
29
Advertisement
Table of Contents
