Changing The Marker Frequency - AOR AR6000 Operating Manual

5-1-4 CHANGING THE MARKER FREQUENCY

To change the marker frequency, press the [CLR] key. A small square black box will appear on the top of
the frequency marker. As you rotate the main dial or sub dial, the frequency cursor will move back and
forth on the spectrum screen.
5-1-5 DEACTIVATING THE SPECTRUM DISPLAY
To exit from the spectrum display, press and hold the [FUNC] key for two seconds.
5-2 MULTI CHANNEL RECEIVE
The AR6000 is capable of monitoring of up to three channels simultaneously.
5-2-1 DUAL CHANNEL RECEIVE IN OFFSET MODE
In VFO mode, any two frequencies above 25 MHz, which are within +/- 5 MHz can be received
simultaneously in offset mode with the following conditions.
1. Both frequencies must be above 25 MHz.
2. The frequency offset must be within +/- 5 MHz.
3. IF bandwidth must be less than 100 kHz.
4. The receive mode must be the same, and must not be WFM.
5-2-1-1 ACTIVATING DUAL CHANNEL IN OFFSET MODE
In VFO mode, press the [FUNC] key, then press the [5] key. The dual frequency display screen
appears on the LCD.
The offset frequencies can also be displayed in the spectrum display mode by pressing and holding the
[FUNC] key for two seconds.
Dual frequency display
33