Jøtul GF 400 CF Installation And Operation Instructions Manual page 9

Logset Installation
Brick Kit Note: Install the optional Antique Brick Kit 55375
before installing the log set. See instructions supplied
with that kit. The GF 400 CF log set must be installed
before operating the burner. The log set includes four
log pieces, packaged inside the firebox, and a quantity of
ceramic embers.
To install the log set, remove the packaging and place
the parts inside the firebox as illustrated in the diagrams
below. Do not handle the log set with your bare hands.
Always wear gloves to prevent skin irritation from the
ceramic fibres.
THE CERAMIC FIBRE LOGS AND EMBERS CAN IRRITATE
YOUR SKIN. GENTLY WASH YOUR HANDS WITH WARM
SOAPY WATER AFTER HANDLING THE LOGS OR EMBERS.
The embers realistically simulate glowing coals when the
burner is operating. These should be spread evenly over
the burner plate and around the logs.
. Engage the holes in the underside 0f the Right Log
with the peg in the burner skirt as in fig. .
. Locate the Rear Log to overlap the Right Log and en-
gage with the pegs as in fig. .
3. Place the Left Log on the peg as in fig. 3.
4. Install Middle Log on the peg as in fig. 4.
5. Install the Cross-over Log on pegs as in fig. 5.
6. Position embers loosely and maintain 6mm clearance
from the burner skirt edges. DO NOT OBSTRUCT THE
PILOT ASSEMBLY OPENING and do not pile the embers
in front of the burner skirt edges. See fig. 6.
7. Lower the glass frame with the glass back into place
and engage the latches.
Figure 11. Install Rear Log.
Figure 12. Install Rear Log.
Figure 13. Install Left Log.
Figure 14. Install Middle Log.
Figure 15. Install Cross-over Log.
Figure 16. Install Ember Stones.
DO NOT OBSTRUCT
PILOT AREA
9