Fuse; Rear Panel - HP 340 Series Service Manual

Fuse
Preliminary Requirements
Turn OFF the SPU and remove these items:
• Power cord.
• Internal assembly
Removal
1. Insert a fiat-tipped screwdriver in the fuse holder and rotate it counter-clockwise and
remove the fuse holder.
2. Remove the fuse from the fuse holder.
Installation.
To install a fuse
1
reverse steps 1 and 2 in the removal procedures.
Rear Panel
~(ith
the case slid off the internal assembly about two inches
(5
cm), only the rear panel needs
to be removed to replace the LAN boards.
For all other printed circuit assemblies, the internal assembly must be removed from the case.
Preliminary Requirements
Turn OFF the SPU and remove these items in the order listed:
1. Power cord.
2. Video and interface cables.
3. Any DIO-I card installed.
Removal
Refer to Figure 2-5 for rear panel fastener locations.
Figure 2-5. Rear Panel Fasteners
Assembly Replacement
31