Dio-I Slot - HP 340 Series Service Manual

Figure 2-8. Processor Board RAM Connector Numbers and Addresses
To remove a RAM board:
1. Put your fingers on the processor board next to the RAM board, for support.
2. Pull the RAM board out from its connector.
Installation
Because the processor board's RAM connectors are wired for a specific address block and RAM
is auto-configuring, the first RAM board installed must go in connector RAM 1, the second in
connector RAM 2, and so on.
If connector RAM 1 is empty, or an empty connector exists between two RAM boards, all
memory boards to the right of the empty connector will not be addressed.
To install a RAM board:
1. Place one hand under the processor board beneath the RAM board connectors as a
support.
2. Place the RAM board over its connector and align the hooked tab with the notch in the
SPU backplane.
2. Seat the RAM board in its connector.
010-1 Slot
Preliminary Requirements
Turn OFF the SPU and remove these items in the order listed:
1. Power cord.
2. Video and interface cables.
3. Any DIO-I card installed.
4. Case.
5. Rear panel.
6. Video/graphics board.
38
Assembly Replacement