Video/Graphics Boards - HP 340 Series Service Manual

Installation
To install a power supply, follow these procedures:
1. Verify the voltage select switch is in the correct position.
2. Set the power supply on its left side and position the processor board (or the rest of the
internal assembly) as shown in Figure 2-7.
Figure 2-7. Positioning Power Supply and Internal Assembly for Installation
3. Look through the hole in the power supply and align the processor board's connector
with the power supply connector.
This permits proper alignment of the processor board's power supply connector to align
correctly with the internal connector.
4. Install the power supply onto the processor board's power supply connector and ensure
the alignment pins on the left-hand board guide fit into the holes on the power supply
chassis.
5. Install the power supply cover plate and screw (Figure 2-6).
6. Replace the rear panel.
7. Replace the case.
Video/Graphics Boards
Preliminary Requirements
Turn OFF the SPU and remove these items in the order listed:
1. Power cord.
2. Video and interface cables.
3. Any DIO-I card installed.
4. Case.
5. Rear Panel
34
Assembly Replacement