Sony PDW-700 Operation Manual page 25

k AUDIO SELECT CH-1/CH-2 (audio
channel 1/2 adjustment method
selection) switches
Select the audio level adjustment method for each
of audio channels 1 and 2.
AUTO: Automatic adjustment
MANUAL: Manual adjustment
l AUDIO IN CH-1/CH-2/CH-3/CH-4
(audio channel 1/2/3/4 input selection)
switches
AUDIO IN CH-1/CH-2 switches
Select the audio input signals to be recorded on
audio channels 1 and 2.
FRONT: Audio input signals from the
microphone connected to the MIC IN
connector
WIRELESS: Audio input signals from the UHF
portable tuner (supplied separately) if it is
installed
REAR: Audio input signals from an audio device
connected to the AUDIO IN CH-1/CH-2
connectors
AUDIO IN CH-3/CH-4 switches
Select the audio input signals to be recorded on
audio channels 3 and 4.
F (FRONT): Audio input signals from a
microphone connected to the MIC IN
connector
W (WIRELESS): Audio input signals from the
UHF portable tuner (supplied separately) if it
is installed
R (REAR): Audio input signals from an audio
device connected to the AUDIO IN CH-1/
CH-2 connectors (The signal input to the
AUDIO IN CH-1 connector is recorded on
channel 3, and the signal input to the AUDIO
IN CH-2 connector on channel 4.)
Left side and upper section
1
2
3 4
GENLOCK
SDI IN
(OPTION)
TEST
OUT
6
a ASSIGNABLE 3/4 switches
You can assign the desired functions to these
switches on the ASSIGNABLE page of the
OPERATION menu.
Nothing is assigned to these switches when the
camcorder is shipped from the factory (equivalent
to a selection of OFF in the menu).
For details, see "Assigning functions to ASSIGN
switches" on page 148.
b Lid of the disc compartment
This opens when the EJECT button on the top
panel is pressed. Press the side of the lid to close.
c SDI IN (OPTION) connector (BNC
type)
d GENLOCK IN (genlock signal input)
connector (BNC type)
• This connector inputs a reference signal when
the camera is to be genlocked or when time code
is to be synchronized with external equipment.
Use the MAINTENANCE menu to adjust the
genlock H-phase (phase of horizontal sync
signal).
Locations and Functions of Parts and Controls
5
IN TC IN
TC
OUT
7
25