Sony PDW-700 Operation Manual page 121

No. Page Item
06 AUDIO-1 FRONT MIC
SELECT
AUDIO CH3/4
MODE
REAR XLR
AUTO
FRONT MIC REF –60dB/–50dB/–
REAR MIC REF
MIN ALARM
VOL
SP ATT LEVEL
HEADPHONE
OUT
07 AUDIO-2 AU REF LEVEL
AU REF OUT
AU CH12 AGC
MODE
AU CH34 AGC
MODE
AU AGC SPEC
AU LIMITER
MODE
AU OUT
LIMITER
Settings Description
MONO/STREO Input mode selection for front microphone.
CH1/2/SW Selects the sources to be recorded to channels CH-
3/4.
CH1/2: Same sources as CH-1/2.
SW: Signals selected by the AUDIO IN CH-3/CH-4
switches.
OFF/ON Turns the XLR connection automatic detection on
or off.
Sets the reference level of the front microphone.
40dB
–60dB/–50dB/– Sets the reference level when the AUDIO IN CH1
40dB connector is set to MIC.
OFF/SET Volume of the monitor speaker alarm tone when it
is turned all the way down.
OFF: Almost inaudible.
SET: Faintly audible.
OFF/3dB/6dB/ Lowers the volume of the monitor speaker. Has no
9dB effect on earphone volume.
STREO/MONO Selects whether to make the rear earphone
monaural or stereo.
–20dB/–18dB/– Sets the output level of the 1 kHz test signal.
16dB/–12dB/
EBUL
EBUL/0dB/ Sets the output reference level.
+4dB/–3dB
MONO/STREO Selects whether to perform automatic input level
adjustment of analog audio signals to be recorded
on channels 1 and 2 independently for each
channel, or in stereo mode.
MONO/STREO/ Selects whether to perform automatic input level
OFF adjustment of analog audio signals to be recorded
on channels 3 and 4 independently for each
channel, or in stereo mode, or not at all (OFF).
–6dB/–9dB/ AGC saturation level setting.
–12dB/–15dB/
–17dB
OFF/–6dB/ For manual audio input level adjustment, selects the
–9dB/–12dB/ limiter saturation level for loud input signals.
–15dB/–17dB
OFF/ON Turns the audio output limiter on or off.
Menu List 121